Yu Yueping
Ningbo Polytechnic, Xinda Str.1069, Beilun District, Ningbo, Zhejiang, 315800, China
Xu Li
Engineering School, Zhejiang University City College, Hangzhou, Zhejiang, 310015, China
ABSTRACT
The study presents the study on the situations of cutting planning of steel plates with the multiple constraints, a mathematical model based on linear programming theory is established. The algorithm has been implemented to optimize the nesting process of large steel plates. The achievements are helpful for the actuality and the higher utilization rate of steel plates of a large-scale steel structure manufacture works.
PDF References Citation
Received: June 05, 2013;
Accepted: October 09, 2013;
Published: November 26, 2013
How to cite this article
Yu Yueping and Xu Li, 2013. Research on Cutting Planning of Steel Plates with Multi-constraints. Journal of Applied Sciences, 13: 5594-5599.
DOI: 10.3923/jas.2013.5594.5599
URL: https://scialert.net/abstract/?doi=jas.2013.5594.5599
DOI: 10.3923/jas.2013.5594.5599
URL: https://scialert.net/abstract/?doi=jas.2013.5594.5599
REFERENCES
- Je, T.J., S.C. Park, K.W. Lee, Y.E. Yoo, D.S. Choi, K.H. Whang and M.C. Kang, 2009. Machining characteristics of complex prism pattern on electroplated roll by copper. Trans. Nonferrous Metals Soc. China, 19: s288-s294.
CrossRef - Jiang, C., X. Han, F.J. Guan and Y.H. Li, 2007. An uncertain structural optimization method based on nonlinear interval number programming and interval analysis method. Eng. Struct., 29: 3168-3177.
CrossRefDirect Link - Krzanowski, J.E., 2009. Fabrication and tribological properties of composite coatings produced by lithographic and microbeading methods. Surf. Coat. Technol., 204: 955-961.
CrossRef - Sapate, S.G., A.D. Chopde, P.M. Nimbalkar and D.K. Chandrakar, 2008. Effect of microstructure on slurry abrasion response of En-31 steel. Mater. Des., 29: 613-621.
CrossRef - Tangjitsitcharoen, S. and T. Moriwaki, 2008. Intelligent monitoring and identification of cutting states of chips and chatter on CNC turning machine. J. Manuf. Processes, 10: 40-46.
CrossRef