HOME JOURNALS CONTACT

Journal of Agronomy

Year: 2006 | Volume: 5 | Issue: 3 | Page No.: 440-450
DOI: 10.3923/ja.2006.440.450
Sorption/Desorption Characteristics of Heavy Metal on Amorphous Al and Fe Hydroxides Formed in the Presence of Oxalate, Citrate and Tannate, Ligands
M. I.D. Helal

Abstract: Sorption capacity of synthetically prepared amorphous Al and Fe hydroxides relative to heavy metal (Pb) was greatly affected by the presence of low (oxalate and citrate) or high (tannate) molecular weight organic ligands during their formation. Co-precipitation of tannate ligand with Al or Fe markedly enhanced the capacity of the precipitation products to sorb Pb. Regarding to oxalate and citrate ligands, their presence suppress the capacity of Al precipitates and enhanced that of Fe ones to sorb Pb. Although the capacity of all Al and Fe precipitates to sorb Pb significantly decreased as pH decreased from 7.0 to 5.5, Fe-Tan and Fe-Cit keep relatively high capacity. Lead sorption consists of fast initial reaction completed in few hours, followed by slow reaction conducted to the end of the experiment. The mols of H+ released per ion Pb sorbed (HR/Sorb.Pb) varied as the adsorbent and sorption density varied and ranged from 1:1 to higher than 2:1. Also, the ratios (HR/Sorb.Pb) increased with the reaction period and ranged from 0.3 to 2.2:1. These different stoichiometries and the delaying of H+ release, refer to formation of different complexes between Pb and adsorbents; an intermediate one {X-O(OH)-Pb2+} with no H+ release may be formed at the beginning; followed by formation of mono-dentate (X-OPb+ ) and bi-dentate (X-O2Pb) ones. Only small portions of Pb previously sorbed on Al and Fe precipitates at pH 7.0 (0 to 16 and 0 to 7.4%, respectively) are reversible. The reversibility increased as sorption density increased and pH decreased. As residence time increased, sorbed Pb, in particular at pH 7.0, was nearly irreversible over a desorption period of 24 h, which indicate the transformation of adsorbed Pb. Pb sorption/desorption characteristics on amorphous Al and Fe precipitates are highly dependent on surface properties, Point of Zero Salt Effect (PZSE) and remaining charge at the same pH (σp). Fe-Tan, Fe-Cit and Al-Tan had high ability to sorb and sequester sorbed Pb over a wide range of pH, which indicate that, these modified hydroxides could be produced and utilize for pollution prevention, remediation of the soil environment and decontamination of heavy metal polluted water.

Fulltext PDF Fulltext HTML

How to cite this article
M. I.D. Helal , 2006. Sorption/Desorption Characteristics of Heavy Metal on Amorphous Al and Fe Hydroxides Formed in the Presence of Oxalate, Citrate and Tannate, Ligands. Journal of Agronomy, 5: 440-450.

© Science Alert. All Rights Reserved