Science Alert
 
   
Journal of Applied Sciences
  Year: 2008 | Volume: 8 | Issue: 5 | Page No.: 876-880
DOI: 10.3923/jas.2008.876.880
Stress Analysis of Marble Sawing Disc in Cutting Process
Ismail Ucun, Mehmet Colakoglu and Suleyman Tasgetiren

Abstract:
In this study, stresses in the marble cutting disc are investigated by finite element method. Normal and tangential forces in stress analysis are considered and critical stress regions are found. Depending on the chosen depth of cut, (i.e., 17.5, 40, 70 and 108 mm) these forces are applied in different values taken from an experimental study. In addition, the equivalent stress is also tried to determine under shock loading which occurs depending on working conditions and hardness of the marble. The analysis is carried out at four different cutting speeds. The results under the normal and shock loads are compared and the possible failure regions are studied.
 [Abstract]   [Fulltext PDF]   [Fulltext HTML]   [References]   [View Citation]  [Report Citation]

COMMENTS
25 January, 2021
Khine Myat Swe:
DEr Sir/MadamPlease provisw full article of Stress Analysis of Marble Sawing Disc in Cutting Process Ismail Ucun, Mehmet Colakoglu and Suleyman Tasgetiren
 
REPLY TO ABOVE COMMENTS
.
 
 
 
 

Are you a human?