Submit Manuscript

Journal of Environmental Science and Technology

Year: 2011 | Volume: 4 | Issue: 3 | Page No.: 302-312
Facebook Twitter Digg Reddit Linkedin StumbleUpon E-mail

Article Trend

Total views 241

Authors

Habtamu Beri

Yingxue Yao

Keywords

Research Article

Effect of Camber Airfoil on Self Starting of Vertical Axis Wind Turbine

Habtamu Beri and Yingxue Yao
Darrieus type Vertical Axis Wind Turbine (VAWT) is attracting many researches for its inherent advantages and its diversified applications. However, a disadvantage is when the rotor is stationary; no net rotational force arises, even at high wind speed. The objective of this study is to show the effect of camper airfoil on self starting of VAWT at low Reynolds. A moving mesh technique was used to investigate two-dimensional unsteady flow around a vertical axis wind turbine. The geometry of the turbine blade was NACA2415 camber airfoil. The turbine model was created in Gambit modeling software and then read into fluent software for fluid flow analysis. Simulations of the model were then conducted for different tip speed ratios. The simulation result shows that camber airfoils have the potential to self start for the modeled airfoil with reduced coefficient of power.
PDF Fulltext XML References Citation

Comments

naseem salim alomoush Reply

i need best airfoil profile for vawt (H-darrieus) to get 100W ,at 5m/s design speed.

Habtamu B.T

The main draw backs with VAWT is self starting at low reynold numbers. the most commonly used airfoil profiles are NACA0012,NACA0015, and NACA0018. however, these profiles have self starting problems. airfoils with self staring airfoils like camber airfoil have efficency problems. therefore, there is no best airfoil profile I recommend.

Leave a Comment

Your email address will not be published. Required fields are marked *