Subscribe Now Subscribe Today
Science Alert
 
Blue
   
Curve Top
Asian Journal of Scientific Research
  Year: 2008 | Volume: 1 | Issue: 3 | Page No.: 222-230
DOI: 10.3923/ajsr.2008.222.230
 
Facebook Twitter Digg Reddit Linkedin StumbleUpon E-mail

Investigating of Tool Wear, Tool Life and Surface Roughness When Machining of Nickel Alloy 242 with Using of Different Cutting Tools

H.H. Habeeb, K.A. Abou-El-Hossein, Bashir Mohamad, Jahara A. Ghani and K. Kadirgama

Abstract:
This study discusses about behavior of cutting tools in term of tool wear, tool life and surface roughness integrity when machining of nickel based alloys 242. Experimental tests were conducted using four different cutting tool materials under wet condition. They are TiAlN, TiCN/TiN, TiAlN/TiN (PVD) and TiCN/Al2O3 (CVD). Tool failure modes and wear mechanism for all cutting tools were examined at various cutting parameters. Flank wear was found to be the predominant tool wear for the four types of cutting tools especially with CVD tools. Coating is observed to be delaminated as main phenomena on all cutting tools surfaces. The obtained results have indicated that PVD cutting tools perform better than CVD cutting tools. The thickness of coating layers for CVD is thicker than PVD. Finite Element Analysis (FEA) is used to support this study in term of analysis of cutting tool deformation and cutting temperature.
PDF Fulltext XML References Citation Report Citation
 RELATED ARTICLES:
  •    Prediction of Contact Temperature on Interaction between Rail and Wheel Materials Using Pin-on-Disc Method
  •    Modeling and Analysis of Material Removal Rate During Electro Discharge Machining of Inconel 718 under Orbital Tool Movement
  •    Development of Surface Roughness Prediction Model for High Speed End Milling of Hardened Tool Steel
How to cite this article:

H.H. Habeeb, K.A. Abou-El-Hossein, Bashir Mohamad, Jahara A. Ghani and K. Kadirgama, 2008. Investigating of Tool Wear, Tool Life and Surface Roughness When Machining of Nickel Alloy 242 with Using of Different Cutting Tools. Asian Journal of Scientific Research, 1: 222-230.

DOI: 10.3923/ajsr.2008.222.230

URL: https://scialert.net/abstract/?doi=ajsr.2008.222.230

COMMENT ON THIS PAPER
 
 
 

 

 
 
 
 
 
 
 
 
 

 
 
 
 
 
 
 

Curve Bottom