Subscribe Now Subscribe Today
Science Alert
 
Blue
   
Curve Top
Journal of Applied Sciences
  Year: 2011 | Volume: 11 | Issue: 10 | Page No.: 1839-1844
DOI: 10.3923/jas.2011.1839.1844
 
Facebook Twitter Digg Reddit Linkedin StumbleUpon E-mail

Stress Intensity Factor for Cracks Emanating from a Shaft

Khoo Sze Wei and Saravanan Karuppanan

Abstract:
Shaft is a rotational body used to transmit power or motion. Due to cyclic loading conditions, surface cracks frequently grow in the shaft. Normally these cracks will propagate with a semi-circular shape and cause premature failure to the whole system. In order to prevent the catastrophic incident, there must be a monitoring system that provides an early warning during the operation of the shafts. The semi-analytical or experimental method applied previously had its own limitations and disadvantages. Hence, there is a great need to determine the stress intensity factor in cracked shafts by using finite element method. The objective of this study is to determine the stress intensity factor for cracks emanating from a shaft by using finite element method and also to verify the finite element results with those obtained semi-analytically. The scope of this study is focused on the semi-circular crack and the crack loadings considered are Mode I and Mode III. This study is divided into two phases. For the first phase, modeling of the cracked shaft was carried out in ANSYS software, while for the second phase; the results obtained from the finite element analysis were compared with those obtained semi-analytically. The relationship between dimensionless stress intensity factor and the normalized relative crack depth is presented in the results and discussion section. The results obtained numerically and semi-analytically had been compared and the deviation in term of percentage is relatively small. In conclusion, the stress intensity factor of a cracked shaft determined by the numerical method was verified to be accurate.
PDF Fulltext XML References Citation Report Citation
How to cite this article:

Khoo Sze Wei and Saravanan Karuppanan, 2011. Stress Intensity Factor for Cracks Emanating from a Shaft. Journal of Applied Sciences, 11: 1839-1844.

DOI: 10.3923/jas.2011.1839.1844

URL: https://scialert.net/abstract/?doi=jas.2011.1839.1844

COMMENT ON THIS PAPER
 
 
 

 

 
 
 
 
 
 
 
 
 

 
 
 
 
 
 
 

Curve Bottom