Subscribe Now Subscribe Today
Science Alert
Curve Top
Journal of Applied Sciences
  Year: 2011 | Volume: 11 | Issue: 10 | Page No.: 1803-1808
DOI: 10.3923/jas.2011.1803.1808
Facebook Twitter Digg Reddit Linkedin StumbleUpon E-mail

Stress Analysis on Direct Joining of Sialon to AISI 430 Ferritic Stainless Steel

C.S. Hassan, P. Hussain and M. Awang

Finite Element Method (FEM) using ANSYS software was employed to evaluate the residual stress distribution in direct joining of sialon and AISI 430 ferritic stainless steel. The elastic-plastic model and four nodes quadratic element PLANE 42 with axisymmetric option were adopted in the analysis. Results showed that sialon experience compressive stresses in radial direction but tensile in axial direction. On the other hand, stresses in AISI 430 ferritic stainless steel are tensile in radial direction but compressive in axial direction. The highest tensile axial stress appeared at the radial free surface of sialon, very near to the joint interface. It is observed that shear stresses concentrated near and on the joint interface.
PDF Fulltext XML References Citation Report Citation
  •    Estimation of a System Performance in Pareto Distribution with Two Independent Random Variables
How to cite this article:

C.S. Hassan, P. Hussain and M. Awang, 2011. Stress Analysis on Direct Joining of Sialon to AISI 430 Ferritic Stainless Steel. Journal of Applied Sciences, 11: 1803-1808.

DOI: 10.3923/jas.2011.1803.1808






Curve Bottom